From the Alliance To Save Energy

No-Cost Low-Cost Tips for Saving Money & Energy

Download a printable PDF file of this information. NO-COST WAYS TO SAVE ENERGY & MONEY Turn off everything not in use: lights, TVs, computers, etc. Check the furnace or air conditioner (AC) filter each month, and clean or replace it as needed. Dirty filters block air flow through your heating and cooling systems, increasing your energy bill and shortening the equipment’s life. During hot months, keep window coverings closed on the south, east, and west windows. In winter, let the sun in. Glass fireplace doors help stop heat from being lost up the chimney. Also, close the fireplace damper when not in use. Activate “sleep” features on computers and office equipment that power down when not in use for a while. Turn off equipment during longer periods of non-use to cut energy costs and improve longevity. When cooking, keep the lids on pots. Better yet, use a microwave oven instead. Dress appropriately for the weather, and set your thermostat to the lowest possible comfortable setting. On winter nights, put an extra blanket on the bed and turn down your thermostat more. In summer, use fans whenever possible instead of AC, and ventilate at night this way when practical. Using fans to supplement AC allows you to raise the thermostat temperature, using less energy. Fans cost less to use than AC. About 15 percent of an average home energy bill goes to heating water. To save hot water, take five-minute showers instead of baths. Do only full loads when using the clothes washer or dishwasher. Switch to cold water washing of laundry in top loading in top-loading, energy-inefficient washing machines to save energy and up to $63 a year—detergents formulated for cold water get clothes just as clean. Lower the temperature on your water heater. It should be set at “warm,” so that a thermometer held under running water reads no more than 130 degrees. Only heat or cool the rooms you need—close vents and doors of unused rooms. LOW-COST WAYS TO SAVE ENERGY & MONEY Install low-flow showerheads and sink aerators to reduce hot water use. Seal and weatherstrip your windows and doors to ensure that you’re not wasting energy on heat or air conditioning that escapes through leaks to the outdoors. A water tank insulation wrap costs about $20 and helps hold the heat inside. Add pre-cut pipe insulation to exposed pipes going into your water heater—it is cheap and easy to install. If you’re starting with an uninsulated tank, the energy savings should pay for the improvements in just a few months. Duct tape works well on lots of things, but it often fails when used on ductwork! Use mastic (a gooey substance applied with a paintbrush) to seal all exposed ductwork joints in areas such as the attic, crawlspace, or basement. Insulate ducts to improve your heating system’s efficiency and your own comfort. Storm windows can reduce heat lost by single-paned windows by 25–50 percent during the winter. As an alternative, you can improve your windows temporarily with plastic sheeting installed on the inside. When buying new products, look for the ENERGY STAR® label, found on more than 40 different products such as TVs, furnaces, cell phones, refrigerators, air conditioners and more. Incandescent light bulbs are outdated; 95 percent of the energy used goes to heating the bulb, adding unwanted heat to your home in the summer. Replace your five most used light bulbs with ENERGY STAR compact fluorescent bulbs to save $60 each year in energy costs. These light bulbs use two-thirds less energy and last up to 10 times longer. Use dimmers, timers, and motion detectors on indoor and outdoor lighting. Consider safer, more efficient ENERGY STAR torchiere lamps rather than halogen torchieres, which can cause fires. Halogen bulbs are expensive to use. THE ULTIMATE CHECKLIST: For Saving Money by Reducing Energy Bills WEATHERIZE & INSULATE Save up to 20 percent of your heating and cooling costs. Warm air leaking into your home during the summer and out of your home during the winter wastes money. A handy homeowner can seal up holes to the outside by weatherstripping doors and sealing windows and other gaps along the home’s foundation. A combination of air sealing and adding insulation to attics, basements, and crawlspaces provides tremendous energy savings and increased comfort. The easiest and most cost-effective way to insulate your home is to add insulation in the attic. If you have less than 6 or 7 inches, you can probably benefit by adding more. Most U.S. homes should have between R-38 and R-49 attic insulation. In order to achieve this, many homeowners should add between R-19 to R-30 insulation (about 6 to 10 inches). Other effective places to add insulation include unfinished basement walls and crawlspaces. Insulating walls can be more complex, but it can be worthwhile to do if you have little or no insulation now. Check with a contractor for advice. Consider the ENERGY STAR® Home Sealing Program—the government’s information for sealing your home: www.energystar.gov/homesealing

“Green Tip” from Stacey Ruffino

Do full loads of laundry and set the rinse cycle to “cold.”

Do appliances really use energy when their plugged in, but not on??

What’s eating away at your cash reserves without your knowledge?

The Bite

No, we’re not talkin’ couch cushions. A phantom load is the energy that’s sapped by appliances when they’re plugged in, but not on. Plug your devices into power strips that you switch off each night to achieve energy symbiosis.

The Benefits

·         Less bank account-leeching. 40% of the electricity used to power home electronics is consumed while they’re turned off.

·         Less parasitic exploitation of the earth’s resources. If we averted phantom loads in all U.S. homes, we could shut down 17 power plants.

·         It’s easier than contracting malaria. Power strips with surge protectors make it easy to “unplug” many appliances at once.

Personally Speaking

All of our offices use power strips, and we love clicking the off switch at night since it means that happy hour is right around the corner.

Wanna Try?

·         Smart Strip Power Strip – smarty-pants device that senses when electronics are off, then “unplugs” them; also has space for “always on” appliances such as clocks and the fridge ($40).

·         Belkin SurgeMaster – has nine outlets, three phone-line inputs, and safety covers for the kids ($29).

·         Intermatic Appliance Timer – a timer that turns off lamps and electronics; use it when you’re outta town ($5).

·         Kill-a-Watt – find out how much energy various appliances are using ($24).

Monthly Tips: Electricity Usage

• Keep cool – in the summer, close your drapes during the day to save on cooling costs
• Keep warm – in the winter, open your drapes to let the sun in and save on heating costs
• Turn off the lights – when going to a meeting, lunch, or leaving for the day remember to turn off your office lights 
• Computer monitors – at the end of the day and at lunch remember to turn off your monitor
  • At 10 cents per kilowatt-hour, turning off one 25-watt flat monitor during down time only saves $1.38 per month, BUT eliminates 225 pounds of CO2 (green house emissions) by burning 135 fewer pounds of coal each year.

CFL Fact Sheet

Have questions about your Green Team gift? Here’s a quick reference for everything CFL. CFL Fact Sheet